Centova Technologies Forum

Centova Cast v3 => General discussion => Topic started by: ThePlacidMan on May 21, 2016, 02:33:29 am

Title: Looking To Relay Stream
Post by: ThePlacidMan on May 21, 2016, 02:33:29 am

Hi there!

I have a Centova Cast V3 Server; I am looking to relay a stream however am confused on how to do it. Not the basic 'relaying' process in the panel, but the stream itself.

listen.radionomy.com/mystationname (don't want to give away the name) is the stream, however I have a feeling I may need the server host name and port number. Is this correct?

If so, should I use the 'connect live' server address and port number which is available, or is it impossible as I would need a different set of information?

Title: Re: Looking To Relay Stream
Post by: Roger on May 21, 2016, 01:53:40 pm

Hello ThePlacidMan,

When setting up a relay, you shouldn't need the "connect live" information, all that you need is the main station's IP address and port, as well as the relay password if there's any.

HTH

Title: Re: Looking To Relay Stream
Post by: SCIFI.radio on July 14, 2016, 05:07:27 pm

Is there any way to SCHEDULE that connection?

Title: Re: Looking To Relay Stream
Post by: Roger on July 14, 2016, 06:12:27 pm

No, I'm afraid currently there isn't a mechanism in place that would allow you to schedule switching on and off a relay.

Title: Re: Looking To Relay Stream
Post by: SCIFI.radio on July 14, 2016, 09:14:45 pm

If one wanted to script that externally to Centova, how would one go about it?