Centova Technologies Forum

Centova Cast v3 => General discussion => Topic started by: SystemN on April 03, 2013, 12:45:30 am

Title: AutoDJ how to start to work !?!?!?
Post by: SystemN on April 03, 2013, 12:45:30 am

Hello,

I have problem to start my AutoDj. I create user configure all setting, copy music and if i click to Start i get this message.

Diagnostics
Tip: Diagnostic mode may provide additional information about the cause of certain problems such as the above. Click here if you would like to retry this operation in diagnostic mode.

When i click here i see this message
Stream could not be started: Could not start server: Application binary has not been configured for ShoutCast on Stream 1 EU.

Can any body help me to tell me what is my problem and how to fix

Thank you

Title: Re: AutoDJ how to start to work !?!?!?
Post by: DJFire_CFR on April 03, 2013, 12:44:23 pm

Did you install/setup Shoutcast ?


Centova Panel > Hosts > (Edit) > Server Software > Check box for Shoutcast

Title: Re: AutoDJ how to start to work !?!?!?
Post by: SystemN on April 03, 2013, 11:19:24 pm

Quote from: DJFire_CFR on April 03, 2013, 12:44:23 pm

Did you install/setup Shoutcast ?


Centova Panel > Hosts > (Edit) > Server Software > Check box for Shoutcast

Hello DJFire_CFR :),

Yes i enable IceCast v2, ShoutCast DNAS v1.x and ShoutCast DNAS v2.x

And in AutoDJ Software i enable ezstream, ices, ices-cc, ices2, sc_trans v1, sc_trans v2

Title: Re: AutoDJ how to start to work !?!?!?
Post by: Centova - Steve B. on April 06, 2013, 01:52:23 am

Enabling an application under Server Software doesn't install the application.  Please read the installation manual for instructions for installing server/source software.  When done correctly, you don't need to change anything at all under Server Software or Source Software; it's all automatically enabled.

Title: Re: AutoDJ how to start to work !?!?!?
Post by: SystemN on April 14, 2013, 04:23:41 am

Quote from: Centova - Steve B. on April 06, 2013, 01:52:23 am

Enabling an application under Server Software doesn't install the application.  Please read the installation manual for instructions for installing server/source software.  When done correctly, you don't need to change anything at all under Server Software or Source Software; it's all automatically enabled.

Hello Steve :),

I install all software, but only complete work Shotcast v2 other version and IceCast not work in any case.

AutoDj only work if Audio encoder in AAC+ if i wont to encoding to Mp3 nothing works.

For same time Server Overrides --> Public server: Never must bi Nerver to be work, but same time i can put other solution.

Thank you,
SystemN